Avionics MEX
Magnetometer & I/O extension
Veronte Avionics’ MEX magnetic compass is a powerful peripheral that includes functionality to improve I/O connectivity in Veronte Autopilot, reducing wiring in autonomous vehicles & increasing the number of devices in the system.
Compass for UAVs & eVTOLs
Magnetometer for high performance avionics.
3-axis magnetometer
The magneto-inductive geomagnetic sensor technology provides high resolution, low power consumption, immunity to large signal noise, a wide dynamic range & high sampling rates to measure the X, Y & Z vector components of the magnetic field.
I/O Expansion Module
Veronte Avionics MEX increases the capacity of input & output ports on Veronte autopilots or other devices. It can be used both to expand I/O in the system & to connect devices with weak signals using a robust communication protocol.
Can Bus Management
The built-in microcontroller performs real-time monitoring of the CAN bus &, in case of anomaly or malfunction, disconnects the equipment, isolating it from the critical communication bus. Redundancy & isolation in the system’s power supply make it resistant to failures.
Categories: Seller: |
Description
Wiring Optimization
Veronte Avionics Mex, in addition to being a magnetometer, increases the number of devices in the system. MEX becomes a quick solution to increase connectivity capacity & allow for cabling optimization, especially in large systems.
I/O Expander Port
Mex increases the number of ports, adding RS232, PWM, RS485, I2C to Veronte Autopilot.
Data Concentrator
The redundant CAN bus increases data capacity by concentrating signals from other ports.
CAN Bus protection
In case of anomaly or malfunction, Mex will isolate the faulty devices from the bus.
Advanced Magnetic Compass
It uses magneto-inductive technology to measure the magnetic field in 3 axes.
Magneto Inductive Technology
Geomagnetic sensor technology offers high resolution, significant immunity to signal noise, wide dynamic range & high sampling rates.
Orientation in 3 Axes
The magnetic compass detects the direction & strength of a magnetic field, including the Earth’s magnetic field, to provide altitude & orientation references for any vehicle.
HMR2300 spare part
Veronte Avionics MEX is a direct replacement for Honeywell MHR-2300 through the serial port. It was widely used in drones & other autonomous vehicles.
Robust Performance
Redundant Communication
Fault Detection
Peripheral Isolation
Robustness & Flexibility
Offered in two different versions: Veronte MEX (protected by a 6061-T6 anodized aluminum housing) & Veronte MEX OEM (smaller & lighter, but requires mechanical protection when installed). Both versions feature reverse polarity protection, ESD protection & independent power supplies to ensure system robustness.
Ready For Certificatio
During the development of Veronte Avionics MEX, the aviation design standards DO178C / ED-12 & DO254 / ED 80 are followed. This allows to ensure hardware & software reliability for eVTOL & UAV certification, as well as for installation on critical autonomous vehicles. In addition, DO160 & MIL-STD-810 tests ensure robustness against adverse environmental conditions.
Specifications
Main Features
Magnetometer: 3-Axis | HMR 2300 drop-in replacement
I/O Expansion: I/O Number Expansion
Data Concentrator: CAN Bus-to-serial, digital input, analog, etc.
Red: Message Filtering | Subnet generation
Bus Protection: Fault Detection | Failure of the chattering idiot
Bus Isolation: Device Isolation
Cable optimization: Long Distances | Protection | Robust bus
Device Interface: Sensors, actuators, ESC, ADS-B, payload, etc.
I/O Extension & Data Interfaces
Buses: 2x CAN Bus | 2x RS232 | 1x RS485 | 1x I2C
Digital I/O: 4x 5VDC PWM | 2x 5VDC ECAP | 1x EQEP
Analog I/O: 2x5V | 1x12V | 1x36V
Power Outputs: 1x 3.3VDC (100 mA) | 1x 5VDC (100mA)
Bus CAN: Double Redundancy | Galvanic isolation
Terminal resistance: Configurable software
Magnetometric Sensor
Technology: Magneto-inductive
Axes: 3-Axis
Scope: ± 1100 μT
Noise: 15 nT
Gain: 75 μT
Linearity: 0.5% (typical)
Sensitivity: 13 nT
Max. Sampling Rate: 147 Hz
Robust Conctruction
Circuit Guards: ESD, overtemperature, short circuit
Power protection: Reverse polarity protection
Connector: 34 Pin | Latch | Vibration Resistant
Construction: Anodized aluminum
Temperature Range: -40 to 60ºC
Weight: 100g | 50g OEM
Safety & Robustness
Power input: 6 – 36VDC | Redundant power input
Power: 3D
Price
Veronte Avionics MEX
MEX 1.0: 900€
MEX OEM 1.0: 800€
Related Products & Services from the same Seller
 Professional grade omni-directional antenna conceived for ground stations. This outdoor all weather antenna permits to perform long range operations with… Company / Seller: |
 Measuring only 3.8 inches long, this compact size 3dBi gain antenna is perfect for small aircraft video transmission. it´s small… Company / Seller: |
 This antenna is intended for use for all 2.4GHz applications. The antenna is fitted with an SMA male connector &… Company / Seller: |
 I/O Expansion & Bus Management
CEX is a peripheral that facilitates the reduction of wiring in autonomous vehicles while increasing the… Company / Seller: |
 Veronte Avionics SDL - RS232 LOS Datalink for drones
Reliable line-of-sight datalink operating at 400MHz, 900MHz or 2.4GHz. It enables wireless… Company / Seller: |
 Datalink robusto basado en XBee 3
XDL24 provides secure data transmission in LOS operations with a robust enclosure. It has a… Company / Seller: |
 Veronte Autopilot electronics for control station enables communications between the PC in the control station & the Veronte Autopilot unit… Company / Seller: |
 Rugged aluminium launcher for unmanned aircraft, excellent to fulfil UAV professionals needs. NM& C200R catapult systems is a folding &… Company / Seller: |